• The "Commander-di" is the latest CNC development in Prehang Machinery. The machine has been designed to machine doors only, or doors with jambs, for hinges and cylinder locks.

 

• "Commander-di" will accommodate either flush or raised molding doors with protrusions up to 7/8" high on one or both sides.

 

• Raised moldings must be a minimum of 4-1/4" from the lock and hinge sides of the door; "Commander-di" will also machine jambs that vary in thickness from 11/16" to 1-1/16" and at the same time as the door, or it can be used to machine jambs only.

 

• Jamb width can vary from 3-1/2" to 7-1/4" when the jambs are attached to the door with hinges. Wider jambs can be machined along with the door and attached after the door has been fed out of the "Commander-di".

 

.• Machining Parameters: 1-3/8" - 2-1/4" door thickness x 18" - 48" door width x 6'6 -10' door length including raised molding doors with moldings up to 7/8" high, and located not less than 4-1/4" from the door edge and jamb width without adjustment from 3-1/2" to 7-1/4" for pre-hanging.

 

• Hinge knuckle height to 5" (max. 4-1/2"x 4-1/2" for pre-hanging) 1/4" or 5/8" hinge radius; no hinge, 2-hinge, 3-hinge, 4-hinge machining sequence; No Lock, 1-lock, or automatic 2-lock machining.

 

• Standard Components: 3-Phase PERSKE high frequency TEFC motors for both hinge and face plate machining; 5 HP 3-Phase face boring motor; 3 HP latch boring motor; GALIL MOTION Control Board and Windows P4 computer in air-conditioned cabinet; precision ground ball screws, bearing rails, and linear ball bearings for CNC movements.

 

• Other equipment:

• Lever Lock Drill Attachment: "A-2" 4" x 4" Hinge & Drill Gearbox Pilot hole drill gearbox for 4" x 4" hinge, including 8-drill hole pattern. Max. drill bit dia. is 5/32".

• 4-1/2' x 8-Drill Gearbox, Pilot hole drill gearbox for 4-1/2" x 4" hinge, including (8) drills. Top & bottom drill sets set to drill for a 4-1/2" x 4" hinge pattern.. Max. drill bit dia. is 5/32".

• Push button Selection for (2) Face Bore Backsets: Push button air switch automatically adjusts for (2) face bore backsets between 2-3/8" and 2-3/4".

• Anti-Static Bar Blow-Off System: Includes static bars above and below the door to positively charge the dust particles and blow them off as the door is fed out of the machine.

 

• (2) KVAL "RT-1" Roll Tables include a Heavy Duty frame made from 1/4" thick angle iron. Rolls are made of non-marking material. Operation height is 38-1/2" and table dimensions are 42" x 70". Footprint Size of 42"x 70".

 

• (2) "SL-2" Straight Lift, lifts doors. - [Ref. DM-010419]

 

The most automated Prehang Line built and in "like new" condition!

 

FOB – West Coast USA

Excellent Condition

USD $234,800